ECONOPLUS - Argentina

Study


Fuel Optimiser How to install it


	1.- Separate the two halves of Fuel Optimiser. Identify the fuel incoming line. This can be done by finding the fuel filter and following the fuel pipe to the engine. The incoming line can usually be identified because it has more pressure and is colder. The return line pressure is usually lower and it is hotter if the engine has been on. When it is difficult to find the pipe it is advisable to resort to the mechanic and ask them to indicate the right pipeline.

	2. - Next, set the seal as shown in the figure so that the opposite side remains open and allows for the fuel pipe to be surrounded.

	3. - Once the two halves have been set to wrap the fuel line, make sure the device, if installed in a plastic or rubber line, is at leat 25 mm. away from any metal item in the fuel line. Make sure all the magnets have been set in parallel.

	4.- Next, put the seal through the opposite side, put it through the fastener at the end of the seal and make sure both halves have been properly adjusted. The halves do not have to touch each other. If that occurs it means the device has not been properly adjusted on the pipe. If this occurs, replace the pipeline.